Trigger System; Calibration Signal; Autoset Mode; General Characteristics - Metrix OX 530 Manual De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

6.3.

Trigger system

Sources
CH1 or CH2
ALT
LINE
EXT
Filters (coupling)
Horizontal mode
Slope
Level
6.4.

Calibration signal

Shape
Amplitude
Frequency
6.5.

AUTOSET mode

• Signal search time ≈ 5 s
• 25 Hz ≤ signal frequency ≤ 30 MHz
• 50 mVpp ≤ amplitude without probe ≤ 160 Vpp
6.6.

General characteristics

Cathode ray tube
Type
Graticule
Screen
Trace
Total acceleration voltage
22
Specifications
Sensitivity in normal mode - Trigger from 0 to 40 MHz
0.5 div.
0 to 10 MHz
1 div.
10 to 20 MHz
1.5 div.
20 to 40 MHz
50 mVrms
0 to 10 MHz
100 mVrms
10 to 20 MHz
700 mVrms
20 to 40 MHz
Bandwidth
AC
10 Hz to 40 MHz
DC
0 Hz to 40 MHz
LFR (rejection) 10 kHz to 40 MHz
HFR (rejection) 0 Hz to 10 kHz
AUTO
Normal
Falling edge
Rising edge
Adjustment range:
Normal mode: ±12 divisions
rectangular
2.5 V ± 1%
1 kHz ± 1%
rectangular 13 cm diagonal with internal grid
8 vertical divisions with 5 sub-divisions
10 horizontal divisions with 5 sub-divisions
1 division = 1 cm
GY phosphorus with average persistence
adjustment of trace rotation, focusing, light intensity
2 kV
Comments
Source depending on display mode:
CH1 trigger CH1
CH2 trigger CH2
ALT trigger CH1 then CH2
CHOP ditto ALT mode
ADD trigger CH1
-CH2 trigger CH2
synchronization on mains
protection ± 420 V (DC + AC peak,
f < 1 kHz)
input impedance: 1 MΩ // 25 pF
Automatic mode
Triggered mode
30 MHz
Chapter II
oscilloscope

Publicidad

Tabla de contenido
loading

Tabla de contenido