AL-KO AMS2 Manual De Instrucciones página 29

Initial start-up
Operation
The speed and direction of movement are selected infinitely variably by moving the joystick.
Note the functional difference between the areas:
Forwards/backwards fig. 4 (1,2)
Turning areas fig. 4 (3,4)
The caravan can be moved infinitely variably in the selected direction in the areas for forwards (1)
or backwards movement (2).
The furthered the joystick is deflected in the required direction, the faster the caravan
moves.
If the joystick is moved straight to the middle arrow of the selected movement direction, the caravan
moves straight in this direction.
If the joystick is moved to the left or right arrow of this movement direction, the caravan moves in
a corresponding curve.
If the joystick is moved sideways into a turning area, the caravan pivots to the right (3) all left (4)
about its own axis.
Please note!
Is no actions are performed after the remote control is switched on, the remote control will switch
off after 5 minutes. The master switch remains switched on. To allow the remote control to be
used again, it is necessary to move the master switch to "0" (OFF) first and then back to "I" (ON).
Pairing the remote control and the system
This step involves transferring the identification of the remote control to the drive controller. The joystick
is calibrated at the same time.
The remote control must be switched off and the system in active.
Working steps
The numbers in brackets in this section refer to figure 2.
Carry out points 2 to 10 within 10 seconds in the caravan with F-C-A (radio CAN adapter)
directly in succession. Do not touch the joystick when doing this. It must be in the central
position to avoid malfunctions.
1. Insert the batteries into the battery compartment of the radio remote control.
Make sure the polarity is correct,
2. Press keys (e and f) simultaneously on the remote control [teach-in mode] and hold them both pres-
sed.
3. Switch on the remote control at the master switch (b) whilst holding the keys pressed.
4. Release keys (e and f).
All LEDs light up briefly one after another.
After this, the LED for the operating status starts to flash red, the LEDs for the maximum drive
temperature and maximum gradeability are continuously lit.
Press keys d and g simultaneously if both LEDs do not light up continuously.
The remote control is now in tandem mode.
5. Press the release button (B) on the F-C-A.
All 4 LEDs light up briefly, go out and are then continuously lit.
All drives are fitted correctly.
6. Press the teach-in button (A) on the F-C-A.
7. Then press keys d and e on the remote control for about 2 seconds.
694 570_b 29