Installation; Assembly; Tube Preparation - SOMFY LS 40 Guía De Usuario

EN

2. INSTALLATION

1
Instructions which must be followed by the drive and home automation professional
installing the drive.
1
Never drop, knock, drill or submerge the drive.
1
Install a separate control point for each drive.
1
Never connect two control points to a single motor.
1
Never connect two motors to a single control point.
1
Never use a double push-button type control point.

2. 1. ASSEMBLY

2. 1. 1. Preparing the drive
1
Check that the inner diameter of the tube is 37 mm or
greater.
Fit the accessories required to integrate the drive in
1)
the roller tube :
‡ (LWKHU ¿W WKH GULYH ZKHHO a) on the drive.
‡ 2U ¿W WKH FURZQ b) and the drive wheel (c) on the drive.
Measure the length (L1) between the inner edge of the
2)
drive head and the rim of the drive wheel.

2. 1. 2. Tube preparation

Cut the roller tube to the required length, depending on
1)
the motorised product.
Deburr the roller tube and remove the swarf..
2)
For roller tubes which are smooth inside, cut a notch
3)
with the following measurements:
Ø 40 x 1.5 mm
Ø 40 x 1 mm
2. 1. 3. Drive/tube assembly
Slide the drive into the roller tube.
1)
For roller tubes which are smooth inside, position the
notch previously cut on the boss on the crown.
Secure the roller tube onto the drive wheel using 3
2)
self-tapping screws or 3 steel pop rivets positioned
between 5 mm and 15 mm from the outer edge of the
drive wheel, for all types of roller tube.
1
The screws or pop rivets must only be attached to the
drive wheel and not to the drive.
22 Images not contractually binding
d e
7 mm 8.5 mm
6 mm 8.5 mm
1)
Ø = 37 mm
a
2)
1)
3)
1)
2)
Copyright © 2007-2014 Somfy SAS. All rights reserved.
Ø > 37 mm
b c
L1 = ...
L1
2)
d
e
L1