Siemens VersiCharge Manual De Instalación Y Funcionamiento página 25

WARNING! Alternate input wiring should be low voltage control wiring.
Installing higher voltage on the alternate control inputs can cause
damage to the alternate control, preventing it from functioning properly.
• The top connector on the alternate input lug block is the low voltage
input from the external control source.
• The bottom connector on the alternate input lug block is Low voltage
output, providing feedback to the external control source on the
charging status of the VersiCharge.
• Remove cap next to terminals to run wire.
• Route control wiring, with proper protection and strain relief, to the
alternate control wire opening.
• Install external control source according to the instructions provided
with that device.
© 2012 Siemens Industry, Inc. Document Number: 813540
- 24 -