Switching To Standby Mode; Inserting And Removing The Hearing Instruments - Siemens Cellion primax Manual Del Usuario

Switching to standby mode
Via remote control or smartphone app, you can switch
your hearing instruments to standby mode. This mutes
the hearing instruments. When you leave standby mode,
the previously used volume and hearing program are
set.
Note:
●
In standby mode, the hearing instruments are not
turned off completely. They draw some power.
Therefore we recommend to use standby mode only
for a short period of time.
●
If you want to leave standby mode, but the remote
control or app is not at hand: Turn your hearing
instruments off and on again (via push button or
by shortly placing them in the charger until one or
more orange LEDs light up). In this case, the default
volume and hearing program are set.
12
Inserting and removing the hearing instruments
Your hearing instruments have been fine-tuned for your
right and left ear. Colored markers
indicate the side:
●
red marker = right ear
●
blue marker = left ear
Inserting a hearing instrument:
Hold the receiver cable at the bend closer to the
X
ear piece.
Carefully push the ear piece in
X
➊
the ear canal .
Twist it slightly until it sits well.
X
Open and close your mouth to
avoid accumulation of air in the
ear canal.
Lift the hearing instrument and
X
slide it over the top of your
➋
ear .
CAUTION
Risk of injury!
Insert the ear piece carefully and not too deeply
X
into the ear.
13