GB
MT
Cleaning and servicing
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this in-
struction guide performed by
a professional. Only use ori-
ginal parts. Allow the device
to cool off before any mainte-
nance or cleaning is underta-
ken. There is a risk of burning!
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the positioning
of screws or other parts. Examine the
grinding disc in particular. Exchange the
damaged parts.
Cleaning
Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
Servicing
Replacing carbon brushes
Switch off the appliance and dis-
connect the power supply. Let the
appliance cool down.
76
1. Loosen the screw (
maintenance cover
2. Remove the maintenance cover
6).
3. Lift the compression spring (20)
out of the groove for the spring
(22) the carbon brush (21).
4. Remove the contact plug (25) of
the contact shoe (24).
5. Pull out the brush (21) from the
guide.
6. Insert a new carbon brush (21)
into the guide.
7. Place the connector (23) in a
bow in the groove for the com-
pression spring (22) past. Lead
the connector (23) through the
side opening of the leadership.
8. Slide the contact plug (25) on
the contact shoe (24).
9. Replace the compression spring
(20) on the nut of the compressi-
on spring (22) the carbon brush
(21).
10. Reattach the screw
maintenance cover
11. Repeat the procedure 1 to 10
on the other side of the unit. The
carbon brushes are always in
pairs to share.
Storage
• Store the appliance in a dry place well
out of reach of children.
• Grinding discs must be dry and stored
upright and should never be stacked.
7)
of the
(
6).
(
(
7)the
(
6)