Precautions For Installation - Panasonic AK-HC1500G Manual De Operación

Precautions for installation

Be sure to ask the dealer for the installation, adjustment and connection of this equipment.
Concerning the mounting screws and drop-prevention wire
Attach the drop-prevention wire as a way to prevent the camera from dropping.
 When the unit is to be mounted onto a Panasonic pan-tilt head, use the mounting
screws and drop-prevention wire that are supplied with the pan-tilt head.
 When the unit is to be mounted onto a surface other than a pan-tilt head, provide your
own drop-prevention wire and camera mounting bracket.
For details of the parts to be provided, refer to the next page.
 Attach the drop-prevention wire to the camera mounting screw hole (Inch screw).
Tightening the mounting screws
Tighten using the torque levels shown in the table below.
After tightening, check for play and unsteadiness.
Screws
Mounting screws (1/4-inch screws)
Mounting screws (/8-inch screws)
Mounting screw for wire (supplied)
(Inch screw: 1/4-20UNC)
Spring washer (supplied)
Flat washer (supplied)
Drop-prevention wire
Pan-tilt head or
camera mounting bracket
When using inch screws (1/4-20UNC), drill
holes with a 7 mm diameter (see page 12).
Flat washers
Spring washers
Mounting screws (Inch screws: 1/4-20UNC)
When using inch screws (3/8-16UNC), drill
holes with a 10 mm diameter (see page 12).
Flat washers
Spring washers
Mounting screws (Inch screws: 3/8-16UNC)
Clamping torque
.0 N • m (0 kgf • cm)
1 N • m (10 kgf • cm)
- 9 (E) -