EdilKamin NILO Instalación Uso Y Mantenimiento página 41

1st SOLUTION: KIT 11 (code 645700) - ADJACENT ROOM ONLY
Note: THE PIPES ON THE HOT AIR OUTLETS MUST BE FITTED BEFORE APPLYING THE COVE-
RINGS AND PRIOR TO DISASSEMBLY OF THE UPPER CAST IRON SIDE FLANK. THE FIRST PART
OF THE FLEXIBLE PIPE MUST BE COMPLETELY "RELAXED" IN SUCH A WAY TO ELIMINATE
CORRUGATION. IN THIS WAY, THE INTERNAL DIAMETER WILL BE SLIGHTLY ENLARGED TO
FAVOUR ENTRANCE.- Define the position of the stove with respect to the walling (fig. a).
- Disassemble the upper part of the back (132) and remove one of the two predrilled caps in correspondence with
the hot air outlet pipes (fig. b).
- Activate the hot air channelling control lever (13), removing the locking plate (133) (fig. b).
- Cut the flue cover to size (6) on the wall side (fig.c)
- Place the stove in its definite position.
- Extend the aluminium pipe (3) for hot air channelling, without connecting the stove outlet.
- Fit the medallion (5) on the aluminium pipe and the pipe cover (6a) without locking it in (fig. c).
- Fit the aluminium pipe to the hot air outlet on the back of the stove (8) (fig. d).
- Replace the upper part of the back (132).
- Place the pipe cover (6) in the definite position and fasten it to the back of the stove with the supplied screws (7) (fig. d).
- Install the terminal outlet (4) and its aluminium pipe (3) (fig. d).
- Fasten the wall medallion (5) with silicone (fig d).
fig. a
fig. c
6
6a
fig. d
8
6a
1 Box
3 Ø 10 pipe
4 Smoke outlet end-piece
5 Wall medallion
6a Flue cover
7 Flue cover fastening screws
8 Pipe blocking clamp
INSTALLATION
3
2
5
8
8
5
4
4
7
6
fig. b
4
3
8
4
8
5
3
6
6a
n°
1
1
1
1
1
4
2
41
132
133
13
132
1
5
7
6 6a
6a
KIT 11
645740
162520
293430
644190
645730
168260
46160