Periodic Maintenance; Fan Replacement; Screen Replacement - Franklin Electric SUBDRIVE UTILITY UT3P Manual Para Propietarios

MAINTENANCE

Periodic Maintenance

Periodic Maintenance

Fan Replacement

In the event that the cooling fan fails and results in Overheated Drive faults, the fan is replaceable.
Refer to "Accessories" on page 38

Screen Replacement

IMPORTANT: The screens should be checked occasionally and cleaned of debris
to ensure proper drive function. As the screen becomes full/blocked, the drive
will reduce output power to avoid excessive internal heat. This may result in
reduced water delivery.
If screens are damaged or lost, replacement screens are available. Refer to
"Accessories" on page 38.
Fan Screen: The fan screen is located on the bottom of the drive enclosure cov-
ering the fan grille.
1. Remove the center screw holding the fan screen in place (if installed).
2. Gently squeeze the retaining clips on the sides of the screen and pull away from the drive.
3. Clear debris from the plastic screen frame and metal mesh screen.
4. Reinstall the plastic screen frame. Ensure the metal mesh screen is properly retained between the drive
enclosure and plastic screen frame.
5. Reinstall the center screw and tighten to 1.5 in-lbs (0.17 Nm) (if previously installed).
Drive Cover Screen: The drive cover screen is located inside the drive as part of the exhaust vent area.
1. Remove power from the drive and allow 5 minutes for internal voltage to dissipate.
2. Remove the drive cover.
3. Remove the two screen retaining screws on the outside of the cover in the exhaust vent area.
4. Remove the plastic screen retainer from the inside of the cover in the recessed exhaust vent area.
5. Remove the metal mesh screen that is placed between the recessed exhaust vent cavity and the plastic
screen retainer.
6. Clear debris from the plastic screen retainer and metal mesh screen.
7. Reinstall the metal mesh screen and plastic screen retainer.
8. Reinstall the two retaining screws and tighten to 5 in-lbs (0.55 Nm).
9. Reinstall the drive cover.
34
for information about Fan Replacement kits.