Accessories; Maintenance Instructions; Tool Storage; Service And Repair - RIDGID 915 Manual Del Operador

915 In Place Roll Groover
7. Install the set screw into the reaction arm and tighten
" hex key to retain the groove shaft.
with 1 /
8
8. Install the pivot pin into the copper reaction arm
making sure the flat is in the "up" position so that it
will accept the thrust washer and the head of the
feedscrew (Figure 19) .
Pivot Pin
Figure 19 – Pivot Pin Position
9. Insert the copper reaction arm into the slot in the
main housing and install the shoulder screw. Tighten
" hex key.
with 1 /
4
10. Thread the feedscrew clockwise into the pivot nut.

Accessories

WARNING
Only the following RIDGID products have been
designed to function with the 915 Roll Groover.
Other accessories designed for use with other
tools may become hazardous when used on this
Roll Groover. To prevent serious injury, use only
the accessories listed below.
Accessories for 915 Roll Groover
" – 1 " Sch. 10/40 Steel pipe
•
Roll Set for 1 1 / 1 /
4 2
•
Roll Set for 4" – 6" Sch. 40 Steel pipe
•
Roll Set for 8" – 12" Sch. 10 Steel pipe
•
Roll Set for 2" – 8" Copper Tube Types K, L, M,
DWV
•
Carrying Case for 915 Groover and Roll Sets
NOTE! A Roll Set consists of a Groove Roll and a
Drive Roll. See Ridge Tool catalog for pipe
stands and vises.
10

Maintenance Instructions

Lubrication with Lithium Base Grease
•
Add grease to the fitting on the back cover until a
small amount is seen at bronze thrust washer at
front of unit.
•
Add grease to fitting in the groove roll shaft until a
small amount is seen at the side of groove roll.
•
Lubricate the feedscrew and thrust washer.
Flat
Groove or Drive Rolls Maintenance
•
Keep groove rolls clean. Use a wire brush to remove
debris.
•
Keep feedscrew clean.
•
Inspect groove and drive rolls and replace if worn or
damaged.

Tool Storage

WARNING
of reach of children and people unfamiliar with roll
groover equipment. This tool can cause serious injury in
the hands of untrained users.

Service and Repair

Service and repair work on this Roll Groover must be
performed by qualified repair personnel. Tool should
be taken to a RIDGID Independent Authorized Service
Center or returned to the factory. All repairs made by
Ridge service facilities are warranted against defects in
material and workmanship.
When servicing the Groover, only identical replacement
parts should be used. Failure to follow these instructions
may create a risk of serious injury.
If you have any questions regarding the service or
repair of this machine, call or write to:
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool
Company at (800) 519-3456 or http://www.RIDGID.com
Ridge Tool Company
Store the tool in a locked area that is out
WARNING
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-Mail: rtctechservices@emerson.com