Singer SE300 Manual De Instrucciones página 14

S S
ETTING OF THE TITCH
desired. Adjusted settings only affect the selected stitch and
will be reset to default when another stitch is selected. Adjusted
settings are not automatically saved when the machine is
turned off.
Increase or decrease the stitch width using + and - buttons.
left or right.
When a setting is changed, the numbers will be highlighted.
When trying to exceed minimum or maximum settings, a
warning sound will be heard.
Increase or decrease the stitch length using + and -
buttons.
stitch density. This may be necessary depending on the
type of thread being used.
When a satin stitch is selected, the icon changes to show
that stitch density is active instead of stitch length.
h. Width Mirroring
to right.
i. Length Mirroring
to bottom.
When mirroring is active, the button will be highlighted. If
mirroring is not available, a warning sound will be heard.
f
h
j. Elongation
be elongated. The entire stitch will be longer but the density
will remain the same. Press the Alt button to show the
elongation setting instead of density for satin stitches. The
density changes to show an elongation symbol. Increase or
decrease the elongation of the satin stitch using the + and -
buttons.
P
ATTERN
g
i
j
S P
EWING REPARATION
MACHINE SETTINGS
S B (A)
ETTING UTTON
Before or during the sewing process, you can adjust the
This screen is scrolled by pressing the right side arrow buttons.
previous screen.
NOTE:
All settings except for thread tension will remain until you
change them. Thread tension will return to pre-set when you
change the pattern. Default settings will differ depending on the
stitch selected.
B
T T (B)
HREAD ENSION
This machine sets the thread tension automatically when
pattern is selected. However, you can change the thread
tension, as follows.
To increase the upper thread tension, press the + button.
To decrease the upper thread tension, press the – button.
If you change from pre-set, number will be highlighted.
while sewing.
Button again.
When another stitch pattern is selected, thread tension will
return to pre-set.
Upper and bobbin thread will lock approximately in the middle
of fabric.
Bobbin thread will appear on the top side of the fabric.
Decrease upper thread tension.
14
A