Start And End Of Seam; Reverse Stitching - Singer SE300 Manual De Instrucciones

STARTING TO SEW
CAUTION
S E S
TART AND ND OF EAM
Refer to page 8 for changing the presser foot.
2. Place the fabric under the presser foot and lower the
presser foot.
press the foot controller pedal.
Keep holding thread after sewing a few stitches.
Lightly guide the fabric while sewing.
Control buttons or the foot control. The buttons are used to
set the speed when using start/stop button and also sets
the top speed when using foot control.
to stop sewing or release the foot controller pedal.
5. Press the Thread Cutter button.
6. Raise the presser foot lifter and remove the fabric.
S T
TARTING
If upper thread is breaking, machine will stop automatically.
Rethread the upper thread and resume sewing.
CAUTION
R S
EVERSE TITCHING
Reverse stitching is used for reinforcing the ends of the seams.
2. Press and hold the Reverse button to sew reverse stitch
until start point.
3. Release the Reverse button and sew forward until reach
the end of seam.
4. Press and hold Reverse button and sew 4-5 reverse
stitches.
5. Release Reverse button and sew until end of seam.
NOTE:
22
S
O EW