Removing/Installing Fabric Seat Cover - Harmony HMYFLDHBB-S3 Manual De Instrucciones

REMOVING/INSTALLING FABRIC SEAT COVER

HEADREST:
1. Locate the snaps (x2) along the top
sides of the headrest; Locate the
plastic hooks (x2) along the top
back of the headrest.
2. Undo snaps (x2) and unhook fabric
from plastic hooks (x2). Remove
fabric headrest cover by gently sliding fabric off each
side of the headrest.
BACKREST:
1. Locate the elastic loops (x4) along
the sides of the backrest.
2. Unhook elastic loops and slide
fabric cover off the backrest.
BASE:
1. Locate the snaps (x2) at the top of
the seat base (where the backrest
meets the base); Locate the fabric
loops at the back/bottom of the
seat base; And locate the elastic
loops (x2) at the very front/bottom
of the seat base.
2. Undo snaps (x2), unhook fabric loops
(x2), and unhook elastic loops (x2).
3. Gently slide fabric cover off the plastic
base from the back of the booster
seat towards the front of the seat.
TO INSTALL:
To reinstall fabric pads, repeat previous steps in reverse order.
TIP: For ease of booster seat BASE pad installation, tilt
the backrest forward slightly to open a gap at base
of backrest to facilitate passing the fabric through
the gap to secure snaps.
26