Electrical Installation; Water Installation; Starting And Use Of The Machine - Dalla Corte supermini Manual De Usuario

electrical installation

The machine is supplied with a feed pipe without a plug. The connection of the machine to the
electric system can be done in two different configurations:
• Connection to the electric system through an appropriated bipolar switch.
• Connection of the supply pipe to the electric network through a certified plug, which must be
accessible after the installation and when the machine is ready to be used.

water installation

• Connect the flexible pipe to the water system.
• Check that there are no narrowings or squashings throughout the flexible pipe.
• Screw the ring nuts of flexible pipes tightly.
• Before connecting the pipe coming from the network and/or the water softener, introduce this
in a recipent and open the tap for some minutes in order to take away possibile remains of the
new pipes.
draining installation
Install the drain flexible pipe on the connection holding the rubber of the drain basin placed under
the basin and put the other end of the pipe directly into the drain siphon. Check that the drain pipe
has the correct sloping to allow the basin to discharge quickly.
ATTENTION
If you do not follow the previous instructions, the safety and the lasting of the machine may be endangered and the warranty
itself decays.

starting and use of the machine

Follow these instructions with the help of the scheme of the machine placed at the end of this
manual (25).
• Turn on the general switch (1a) of the machine on position 1 and check that the line indicator
lights up.
• Immediately after switching on the machine, the automatic auto-level starts filling the boiler and
the indicators (2) of the keyboard (3) start flashing. When the boiler has been charged , the
coffee-group starts heating (4) for about 7 minutes.
• When the indicators (2) stop flashing, the group (4) has reached the correct thermal level and
can be used to make coffee.
• When the group has the correct thermal level, you can turn on the switch (1b) to heat the boiler.
• When the manometre controlling the boiler pressure reaches 1,5 bar, it is possibile to use the
drawing tap for steam (5) and hot water (6).
21