Installation - Dalla Corte Evolution Manual De Usuario

installation

• Place the machine on a surface that guarantees a secure support.
• To get ready for set up, make sure you have an opening (A-Pic.1) on the support surface to allow
connection with systems in the space below (B-Pic.1).
• The machine should be connected to a source of cold drinking-water.
• The water pressure should be between 1 and 5 bar. If this is not possibile, please contact the
manufacturer.
• A tap should be placed on the water supply (1-Pic.1) so that the water passage can be closed
in case of need.
• The discharge siphon should have a 40 mm (5-Pic.1) diameter which should be connected to
the drainage set up (4-Pic.1).
• The machine is not endowed with a plug (6-Pic.1), to be connected in a fixed manner to the
electrical supply, therefore one must have an installation on/off switch (7-Pic.1).
- Water tap
1
- Flexible water hoses
2
- Water softener (optional)
3
- Drain hose
4
- Drain Siphon
5
- Electrical supply cable
6
- ON / OFF Switch
7
A - Opening on support surface
B - Under counter space
WARNING
• For a good performance and maintenance of the machine, it may be necessary to install a water
softener in order to avoid the creation of calcium deposits.
• This evaluation must be made by the installer, and the user must provide him with the appropriate
space for the installation of the water softener according to the indications contained in the
instructions' book.
All manuals and user guides at all-guides.com
Pic 1
1
3
A
2 4 6
5
B
7
19