Attaching The Seal For The Cab Roof; Preparing The Unit; Installing The Unit In The Sunroof - Dometic CoolAir RT 780 Manual Del Usuario

Installation
7.3

Attaching the seal for the cab roof

A
NOTICE!
Ensure that the adhesive surface for the seal between the unit and the cab roof
is clean (free of dust, oil, etc.).
➤ Stick the insulating tape to the cab roof (fig. 7).
➤ Provide the abutting edge and the top edge of the insulating tape with an
unhardened plastic butyl sealing compound (e.g. SikaLastomer-710).
7.4

Preparing the unit

A
NOTICE!
• During preparatory work on the surfaces, secure the unit from falling down.
• Make sure that the work surface is clean and level to ensure that the unit is
not damaged.
• Do not exceed the specified torque under any circumstances. This is the
only way to ensure that the thread inserts are not torn out.
Proceed as follows (fig. 8):
➤ Place the air conditioning roof unit on a work surface with the housing facing
down.
➤ RT780 only: Screw in the self-threading thread inserts in the corresponding
blind holes.
➤ Fix the two sheet metals as shown.
7.5

Installing the unit in the sunroof

➤ Set the unit down centrally aligned and in the direction of travel (fig. 9) on
the sunroof opening.
I
NOTE
Make sure the air conditioning roof unit is centred perfectly. The seal must be
applied continuously around the air conditioning roof unit after being placed
on the roof of the vehicle. This is the only way to ensure a tight seal.
A
NOTICE!
Do not exceed the specified torque under any circumstances. This is the only
way to ensure that the thread inserts are not torn out.
➤ Fix the parking cooler in place as illustrated (fig. 0)
12
CoolAir RT780, SP950T
EN