Removing The Sunroof; Preparing The Unit; Attaching The Seal For The Cab Roof - Dometic COOLAIR SP 950T Instrucciones De Montaje

CoolAir SP950T
7.2

Removing the sunroof

➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean and free
of grease.
I
NOTE
Dispose of all waste material, glue, silicone and seals separately. Observe the
local disposal guidelines.
7.3

Preparing the unit

A
NOTICE!
During preparatory work on the surfaces, secure the unit from falling down.
Make sure that the work surface is clean and level to ensure that the unit is not
damaged.
➤ Place the air conditioning roof unit on a work surface with the housing facing
down.
➤ Fix the two sheet metals (fig. 3 2, page 3) with 3 rounded head screws
M8 x 16 mm (fig. 3 1, page 3) each in the thread inserts (fig. 3 3, page 3).
A
NOTICE!
Do not exceed the specified torque under any circumstances. This is the only
way to ensure that the thread inserts are not torn out.
➤ Tighten the screws with a torque of 10 Nm.
7.4

Attaching the seal for the cab roof

A
NOTICE!
Ensure that the adhesive surface for the seal between the unit and the cab roof
is clean (free of dust, oil, etc.).
➤ Stick the 2.5 m insulating tape (10 x 20 mm) to the cab roof, following the
outline of the sunroof opening (fig. 4, page 4).
➤ Provide the abutting edge and the top edge of the insulating tape with an
unhardened plastic butyl sealing compound (e.g. SikaLastomer-710).
EN
Installation
19