Removing The Sunroof; Preparing The Unit - Dometic CoolAir RT 780 Instrucciones De Instalación

CoolAir RT780
7.2

Removing the sunroof

➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean
and free of grease.
I
NOTE
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
7.3

Preparing the unit

A
NOTICE!
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
A
NOTICE!
Screw in the thread insert vertically.
Do not exceed the screw torque of 10 Nm.
➤ Screw in the 8 self-threading M8 thread inserts in the blind holes
marked with "1" (fig. 3 1, page 4).
Use the supplied 1/4" bit for this.
➤ Screw in the 6 self-threading M8 thread inserts in the blind holes
marked with "2" (fig. 3 1, page 4).
Use the supplied 1/4" bit for this.
➤ Fix the two sheet metals (fig. 4 2, page 4) with 3 rounded head
screws M8 x 16 mm (fig. 4 1, page 4) each in the thread inserts
marked with „2" .
A
NOTICE!
Do not exceed the specified torque under any circumstances. This is the
only way to ensure that the thread inserts are not torn out.
➤ Tighten the screws with a torque of 10 Nm.
EN
Installation
17