Removing The Sunroof; Preparing The Unit Fastening; Preparing The Unit - Dometic Waeco CoolAir RT880 Instrucciones De Instalación

Installation
6.2.1

Removing the sunroof

➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean
and free of grease.
I
NOTE
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
6.2.2

Preparing the unit fastening

➤ Enlarge the existing
a diameter of 8.5 mm (fig. 5 5, page 4).
6.2.3

Preparing the unit

A
NOTICE!
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
A
NOTICE!
Screw in the thread insert vertically.
Do not exceed the screw torque of
 8 Nm for M6
 10 Nm for M8
➤ Screw in the 8 self-threading M8 thread inserts in the blind holes
marked with "1" (fig. 3 1, page 3).
Use the supplied 1/4" bit for this.
➤ Screw in the 4 self-threading M6 thread inserts in the corresponding
blind holes on the left and right of the outlet unit as shown in fig. 3 2,
page 3.
Use a 5 mm hexagon bit for this.
34
6.5 mm drill holes for fastening the sunroof to
∅
CoolAir RT880
EN