Adjusting Nylon Line - Stihl FSE 60 Manual De Instrucciones

English / USA
1
3
2
4
Mounting STIHL AutoCut C 5-2
Mowing Head
: Slide the mowing head (1) over the
shaft (2) and engage hexagon
recess (3) on external hexagon (4).
18
6
2
5
: Screw the spool (5) clockwise until
the two arrow points are in
alignment – secure the spool in this
position.
: Fit cap (6) in the spool, press it
down as far as stop and rotate it
clockwise at the same time.
: Rotate cap as far as stop and
tighten down by hand.
2
1

Adjusting Nylon Line

STIHL AutoCut
: Hold the rotating mowing head
horizontal to the ground – tap it on
the ground – about 1 1/4" (3 cm)
fresh line is advanced.
: The blade (1) on the deflector (2)
trims surplus line to the correct
length. Avoid tapping the head more
than once.
Line feed operates only if both lines
are at least 1" (2.5 cm) long.
FSE 60