Mounting The Loop Handle; Mounting The Deflector - Stihl FSE 60 Manual De Instrucciones

English / USA

Mounting the Loop Handle

A
1
4
5
3
40 mm
(1.57 in)
Mounting the loop handle
: Fit the loop handle (1) over the
drive tube at a distance A of about
12" (30 cm) in front of the control
handle (2).
: Insert the hex nut (3) in the loop
handle and fit screw (4) with washer
(5) from the other side. Tighten
down firmly.
16
Moving loop handle to most
comfortable position
: Loosen the screw (4).
: Slide the loop handle along the drive
tube to the required position.
: Tighten the screw firmly.
2

Mounting the Deflector

2
1
4
: Push deflector (1) onto clamp (2)
as far as stop.
: Fit locknut (3) in the hex recess on
the deflector.
: Make sure the holes line up.
: Insert and tighten down screw (4).
3
FSE 60