Mounting The Drive Tube - Stihl FSE 60 Manual De Instrucciones

Ocultar thumbs Ver también para FSE 60:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USING THE CUTTING TOOLS
For an illustration of the various cutting
tools and instructions on proper mount-
ing see the chapter on "Mounting the
Mowing Head" in your owner's manual.
Using the mowing heads
The STIHL Autocut mowing head
produces a clean and tidy finish. It is to
be used only on trimmers equipped with
a line-limiting blade in the deflector in
order to keep the line at the proper
length (see "Parts and Controls" chapter
of this manual).
FSE 60
!
Warning!
To reduce the risk of serious injury,
never use wire or metal-reinforced line
or other material in place of the nylon
cutting lines. Pieces of wire could break
off and be thrown at high speed toward
the operator or bystanders.
STIHL Autocut 5-2 mowing head
Nylon cutting cord advances auto-
matically when tapped against the
ground.
!
Warning
Do not use with mowing line larger than
the intended diameter. With a properly
mounted guard, the built-in cutter will
automatically adjust the line to its proper
length. Overly long lines can overload
the motor, resulting in damage to the
motor and nearby parts.
English / USA

Mounting the Drive Tube

2
3
A
:
Pull the protective cap off the drive
tube.
:
Push the drive tube (1) into the
motor housing (2) as far as the
mark (A), turning the drive tube
back and forth at the same time.
:
Tighten down the screw (3) in the
housing.
1
A
15

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido