Setup Menu; General Remarks; Opening The Setup Menu - Würth ACCTIVA EXPERT Manual De Instrucciones

Setup menu

General remarks

Important! The following section only applies to the standard control panel (LED versi-
on).
Select the characteristic type in the setup menu depending on either the battery that
needs charging or the requirement as specified in the „Characteristic" section.
Opening the Important! Do not connect the charging cable to the battery. If the charging terminals
setup menu
are connected, no characteristic type can be selected.
1.
2.
3.
4.
Connect mains cable to charger and plug into mains
Charger in open circuit - both Ready indicators light up
12 V
Press and hold Stop/Start button for approx. 10 secs to call up the setup menu
approx. 10 secs
Both Ready indicators go out
The charger is in setup mode
12 V
The display also shows the selected characteristic type
24 V
24 V
10