EXFO FTB-500 Guía Del Usario página 455

Communicating Through TCP/IP over Telnet
Executing SCPI Commands Over Telnet
To connect through TCP/IP over Telnet from a remote
Windows client:
1. From your computer, start Windows.
2. On the taskbar, click Start (Start button (
) under Windows 8.1) and
select Run.
3. In the Open box, type telnet, and then click OK.
Note: If you receive an error message, it probably means that the Telnet client is
not already activated on your computer. In this case, in the Open box, type
pkgmgr /iu:TelnetClient, and then click OK to enable the client. Once it is
done, perform step 3 again.
447
FTB-500