Alarm System R10 Shutter Remote Control - Gardesa Biptronic Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GB
R10 SHUTTER REMOTE CONTROL
The bi-directional radio-wave R10 remote control is the device
which partially activates and deactivates the alarm system.
The R10 remote control allows the user to activate and deactivate
the two motion zones (V10 sensors) and the perimeter (P10 sensors)
independently from each other.
The commands to turn on and off each of the system zones are given
by the user by pointing the tip of the C10 electronic key towards
the remote control, near the zone reference leds and by pressing the
RED activation button or the GREEN deactivation button.
As a consequence of this operation, the R10 remote control
transmits the selected command to the alarm system and to the
armoured door.
The remote control is equipped with 3 leds which indicate the
operating status of the two motion zones (V10 sensors) and of the
perimeter (P10 sensors).
There is also a buzzer for acoustic signalling.
PERIMETER
LED
TECHNICAL DATA:
- Power supply: 1 lithium battery, 3.6V 3,3 Ah size A
- Lifetime: 3 years with 2 alarm on/off cycles a day and a Biptronic
system that generates 250 alarm messages a day
- Radio-wave transmitter frequency: 433 MHz
- Radio transmitter range: 10÷15 m in residential installations
- Receiver sensing range: 100dB
- Operating temperature: from - 10 to +50 °C
48
ALARM SYSTEM
ANTENNA
ZONE 1
LED
ZONE 2
LED
MTPBB06-25 - Rev. 00
1
2

Publicidad

Tabla de contenido
loading

Tabla de contenido