V10 And P10 Sensor - Gardesa Biptronic Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The battery should be replaced when its charge is low (led fl ashing
every half-second).
V10 sensor
1 - Unscrew the retaining screw
on the top of the sensor
housing and remove the
sensor from its mount.
2 - Remove the battery and
fi t the new lithium battery
in its seat, in the indicated
polarity orientation.
3 - Briefl y press the reset button
to initialise the sensor. The
led below the lens will turn
on for 3 seconds.
4 - Remove the sensor to its
mount fastened onto the
wall.
MTPBB06-25 - Rev. 00
V10 AND P10 SENSORS
MAINTENANCE
P10 sensor
1 - Use a screwdriver to lift
the retaining tab on the top
of the sensor housing and
remove the sensor from its
mount.
GB
63

Publicidad

Tabla de contenido
loading

Tabla de contenido