Changing The Alarm System Code - Gardesa Biptronic Manual De Instrucciones

GB

CHANGING THE ALARM SYSTEM CODE

The alarm system components (electronick lock T20-T30 siren
S10, sensor V10 and P10, R10 shutter remote control, J10 repeater
unit, and GSM dialer) are connected to each other exclusively by
radio-waves.
Signals between the components contain a common "access code"
(or transmission code) which is individually set during installation
of the system.
The transmitter location code is set by the DIP switches inside the
V10 and P10 sensors, on the electronic card of armoured doors
and learned by the S10 siren, by the R10 shutter remote control,
the J10 repeater unit and the GSM dialer.
The system access code can only be changed by the installation
technician.
56
MTPBB06-25 - Rev. 00