R10 Shutter Remote Control - Gardesa Biptronic Manual De Instrucciones

R10 SHUTTER REMOTE CONTROL

LOW BATTERY CHARGE INDICATION
Low battery charge is shown each time the alarm system is armed
and disarmed using the R10 remote control. The three LEDs light
one after the other from top to bottom for about 10 seconds.
REPLACING THE BATTERY
1 - Remove the battery housing
cap from the base by levering
out the retaining tab on the
upper part of the said base
using a screwdriver.
2 - Remove the old battery
and quickly insert a new
one in the right position
(positive/negative poles).
If you don't do this quick
enough (a memory failure
causes the alarm system
code to be lost), press the
reset key briefl y. You will
hear a beep and the three
LEDs will light up for 10
seconds, during which
time you should re-enter
the aforesaid code.
3 - Within 10 seconds from
resetting the R10 shutter
remote control, press the
RED C10 key near the
magnetic sensor on the
external plate fi rst then wait
for the fi rst melody from
the shutter remote control
(system code accepted).
Then press the GREEN
C10 key and wait for the
second melody from the
shutter remote control
(system code confi rmed).
MTPBB06-25 - Rev. 00
MAINTENANCE
BASE
LITHIUM
BATTERY
3,6V
GB
MOLLETTA DI
AGGANCIO ????
COVER
BACK
COVER
ELECTRONIC
LOCK
TURN ON THE
SYSTEM
ELECTRONIC
LOCK
TURN OFF
THE SYSTEM
61