Replacing The C10 Electronic Keys - Gardesa Biptronic Manual De Instrucciones

GB
T20 -T30 ARMOURED DOOR

REPLACING THE C10 ELECTRONIC KEYS

Replacing the C10 electronic key also requires the access code for
the door lock functions to be replaced, and hence the key must be
reprogrammed.
This is done via the lock electronic control board.
Proceed as follows:
1 - Remove the handle on the
inside of the door, using a
screwdriver to prise off the
bolt cover at the top and
bottom as shown in the
diagram.
For T30: use a screwdriver to
remove the keypad from the
internal door plate.
2 - Press the reset key B briefl y.
The buzzer on the sensor
board emits a long beep. The
electronic card will now wait
to receive the access code for
the new C10 magnetic key.
3 - Point the tip of the C10
magnetic key about 2 cm
from the external plate
sensor and press one of the
keys on the panel twice.
The buzzer on the sensor
control card will beep the
fi rst time the key is pressed
to confi rm that the code has
been saved to the key. The
buzzer will beep again as
the key is pressed a second
time to confi rm the key code
acquisition procedure has
been completed.
4 - For T30: replace the keypad
in its original position.
Snap the cover plate back on
and turn the knob.
58
MTPBB06-25 - Rev. 00
T20
T30