Gardesa Biptronic Manual De Instrucciones página 49

OPERATION
INDIVIDUAL ZONE ACTIVATION
To activate the alarm for a single zone (sensors V10 in zone 1 or 2)
or the perimeter (sensors P10), point the tip of the C10 key close
to the relative indicator LED on the remote control and press the
red key lightly on the C10 key.
The remote control emits a
double "beep" and broadcasts
the activation
command to the alarm
system.
The indicator led in the
activated zone fl ashes every
2 seconds permanently.
This will enable the siren to
receive alarm messages from
sensors in zone 1 or 2 (sensors
V10) or from the perimeter
(sensors P10) after 60 seconds
(exit time).
SYSTEM OFF
It is not possible to deactivated a system zone individually. To
simultaneously deactivate zones 1 or 2 (sensors V10) or the
perimeter (sensors P10), point the tip of the C10 key against one
of the indicator LEDs on the remote control and lightly press the
green key on the C10 key.
The remote control emits a
single "beep" and broadcasts
the deactivation command
to the alarm system. The
indicator leds currently on
will turn off.
This deactivates the siren,
stopping it from receiving
alarm messages in real time
from any of the sensors.
SYSTEM STATUS TEST
In order to test which and how many zones are active, touch one
of the three signalling LEDs of the remote control R10 with the
tip of the electronic key C10.
Press the white button of the key C10 until a beep is emitted by
the remote control R10 and the zones are activated.
MTPBB06-25 - Rev. 00
GB
49