Transport And Handling; Machine Identification; Installation And Prelimi- Nary Opera- Tions - Nuova Simonelli Aurelia Vip Plus Manual De Instrucciones

3.

TRANSPORT AND HANDLING

3.1
MACHINE
IDENTIFICATION
Always quote the machine serial number in all
communications to the manufacturer, Nuova
Simonelli.
3.2
TRANSPORT
The machine is transported on pallets which
also contain other machines - all boxed and
secured to the pallet with supports.
Prior to carrying out any transport or handling
operation, the operator must:
• put on work gloves and protective footwear,
as well as a set of overalls which must be
elasticated at the wrists and ankles.
The pallet must be transported using a sui-
table means for lifting (e.g., forklift).
44
3.3
HANDLING
RISK OF IMPACT OR CRASHING
During all handling operations, the operator
must ensure that there are no persons,
objects or property in the handling area.
The pallet must be slowly raised to a height
of 30 cm (11,8 in) and moved to the loading
area. After first ensuring that there are no
persons, objects or property, loading opera-
tions can be carried out.
Upon arrival at the destination and after
Fig. 8
ensuring that there are no persons, objects
or property in the unloading area, the pro-
per lifting equipment (e.g. forklift) should be
used to lower the pallet to the ground and
then to move it (at approx. 30 cm (11,8 in)
from ground level), to the storage area.
RISK OF IMPACT OR CRASHING
Before carrying out the following operation,
the load must be checked to ensure that it is
in the correct position and that, when the
supports are cut, it will not fall.
The operator, who must first put on work
gloves and protective footwear, will pro-
ceed to cut the supports and to storing the
product. To carry out this operation, the
technical characteristics of the product
must be consulted in order to know the
weight of the machine and to store it accor-
dingly.
4.
CAUTION
After unpacking, assess that the machine and
its accessories unit are complete, then proceed
as follows:
NOTE: the unit grooves have to face upwards,
CAUTION
It is advisable to install a softener (1) and then
a mesh filter (2) on the external part of the
plumbing system, during preliminaries and after
levelling the machine.
In this way impurities like sand, particles of cal-
cium, rust etc will not damage the delicate gra-
phite surfaces and durability will be guaranteed.
INSTALLATION
AND PRELIMI-
NARY OPERA-
TIONS
• place the machine so that it is level on a flat
surface;
• assemble its supporting feet by inserting
the insert into the cylindrical unit;
• twist the rubber foot into the screw thread
inside the unit;
• screw the whole assembled unit into the
allotted setting for the machine's adjustable
feet;
• level the machine by regulating the adjusta-
ble feet;
as shown in the following illustration.
Fig. 9