Using Your Monitor For The First Time; Installing The Batteries; Setting The Date And Time - Microlife BP3NQ1-4X Manual De Instruccion

b) Wide Range Cuff:
For arm circumference 22cm - 42 cm (8.7" - 16.5")
If you ever need to buy a replacement cuff, use only
Microlife brand cuffs. Call Microlife customer service at
1-800-568-4147 for information.
Please Note:
rm circumference should be measured with a measuring tape in the middle of the
relaxed upper arm. Do not force cuff connection into the opening. Make sure the cuff
connection is not pushed into the C adapter port. If the cuff is too small, call 1-800-
568-4147 for further information. You may prefer to use one of our wrist type moni-
tors.

4. Using your Monitor for the First Time

4.1 Installing the batteries

Insert batteries immediately after unpacking the unit. The
battery compartment is located on the bottom of the device.
a) Remove cover.
b) Insert the batteries (4 x size
observing the indicated polarity.
c) If a battery warning appears in the display,
the batteries are discharged and must be
replaced.

4.2 Setting the date and time

1. fter the new batteries are activated, the year number
flashes in the display. You can advance the year by
pressing the "M" button. To confirm and then set the
month, press the time button.
2. You can now set the month using the "M" button. To
confirm and then set the day, press the time button.
3. Please follow the instructions above to set the day, hour
and minutes.
4. Once you have set the last minute and pressed the time
button, the date and time are set and the time is dis-
played.
5. If you want to change the date and time, press and hold
the time button down for approx. 3 seconds until the
user icon starts to flash. Release and press the time
button once more and the year will begin flashing. Now
you can enter the new values as described above.
6
1,5V),
Memory
Button
Time/Date
Button