Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.11. Using the C dapter
You may also operate this monitor using the included C dapter (output 6V
DC/600 m with DIN plug).
Use only the included C dapter to avoid damaging
the unit.
1. Ensure that the C adapter and cable are not damaged.
2. Plug the adapter cable into the C dapter port
on the blood pressure monitor.
3. Plug the adapter into your electrical outlet.
When the C adapter is connected, no battery current is consumed.
Note: No power is taken from the batteries while the C dapter is connected to
the monitor. If electrical power is interrupted, (e.g., by accidental removal of the
C adapter from the outlet) the monitor must be reset by removing the plug from
the socket and reinserting the C adapter connection. Please consult Microlife if
you have any questions regarding the C adapter by calling 1-800-568-4147.
6. Software Functions
This unit can be used in connection with
your personal computer (PC) running the
PC Link Blood Pressure nalyzer soft-
ware. Your PC will allow a capacity of
monitoring 80 patients, each with 1000
data (note: overuse will lower system
efficiency). The memory data can be
transferred to the PC by connecting the monitor via the included USB cable with
your PC. Note: The software does not work with Mac computers.
6.1. Installation and Data Transmission
a) Insert CD into CD ROM drive of your PC. The installation
will start automatically. If not, click on SETUP.EXE.
b) Connect the monitor via USB cable with the PC. Three hori-
zontal bars will appear on the display and last for 3 seconds.
c) The bars will then flash to indicate that the connection
between computer and device is successfully made. s long
as the cable is plugged, the bars will keep flashing and the
buttons are disabled.
During the connection, the device is completely controlled
by the computer. Please refer to the 'help' file in the software
for detailed instructions or call 1-800-568-4147.
16
- - -
1
- - -
1
Publicidad
Capítulos
Tabla de contenido
