Programming; Description Of The Programming Buttons; Auto-Programming - SOMFY pujol SPIDER PRO 600 Instrucciones De Instalación Y Reglaje

PROGRammING

Description of the programming buttons

Warning light legend:
off
flashing

auto-programming

[1]. Control the motor with button "a" so that the transmission shuttle is engaged on the carriage and bring the door to the closed position:
. Keep pressing button "a" to cause the shuttle to move.
. Release the button to stop the movement.
. Press button "a" again to trigger movement in the opposite direction.
- Release button "a" before forcing the motor on the door.
[3]. Adjust the closed position using button "a".
- Release button "a" before forcing the motor on the door.
[4]. Press "B" to launch the auto-programming cycle.
The door performs a complete Opening-Closing cycle.
- If the auto-programming is correct, warning light B goes out.
- If the auto-programming cycle was not successful, warning light B continues to flash (2 flashes).
During auto-programming:
- If the door is moving, the movement is stopped and auto-programming is interrupted if any of the buttons are pressed.
It is possible to access auto-programming mode at any moment including when the auto-programming cycle has already been completed.
Note: The remote controls supplied in the kit have already been memorised.
at this stage of the installation, the Spider Pro 600 motorisation is ready to operate.
SPIDER PRO 600
. Triggering of auto-programming
. Memorising/clearing the remote controls
. Modifying a parameter value
. Use of forced operating mode
. Selecting a parameter
. Parameter warning light selected
Warning light a
Warning light B . Parameter value warning light
. Fault indicator warning light
fig. 15
automatismos pujol -
https://appceso.com
5
- english