Specific Operation; Clearing The Remote Controls And All Settings; Clearing The Remote Controls; Reinitialising All The Settings - SOMFY pujol SPIDER PRO 600 Instrucciones De Instalación Y Reglaje

memorising the remote controls for operation in «Total opening» mode
The remote controls supplied in the kit have already been memorised.
It is possible to memorise up to 32 control channels.
If this procedure is carried out using a channel which has already been memorised, this channel will be cleared.

SPECIfIC OPERaTION

See the user booklet.

ClEaRING ThE REmOTE CONTROlS aND all SETTINGS

Clearing the remote controls

Press button "B" until the light flashes (7 secs).
Causes all memorised remote controls to be cleared.
Reinitialising all settings
[1]. Press button "a" 3 times to access the
[2]. Press button «B" to enter auto-programming mode. Warning light B flashes twice continuously.
[3]. Control the motor with button "a" so that the transmission shuttle is engaged on the carriage and brings the door to the closed position.
[4]. Press "B" to launch the auto-programming cycle.
The door performs a complete Opening-Closing cycle.
- If the auto-programming is correct, warning light B goes out.
- If the auto-programming cycle was not successful, warning light B flashes twice continuously.

REfITTING ThE COvER flaP

Fit the cover flap.

DIaGNOSTICS

Warning light B meaning
Motor waiting for auto-programming
2
Cell fault
3
Motor thermal protection device
5
Motor current measuring circuit fault or sensor fault
6
Maximum power delivered by the motor reached during the
7
auto-programming phase
SPIDER PRO 600
fig. 26
fig. 27
auto-programming parameter.
(fig. 28)
automatismos pujol -
https://appceso.com
Solution?
Start auto-programming
Check that no obstacles prevent the cells from detecting.
Check the wiring of the cells or create a bridge between
terminals 1 and 2 if no cells are installed.
Check the correct alignment of the cells.
Leave the motor to cool until the fault disappears.
Switch off the power supply (mains and backup battery), wait
a few minutes then reconnect the power supply.
Perform an auto-programming cycle. If the fault remains,
contact automatismos pujol technical assistance.
Product has reached operating limit.
7
- english
fig. 25