Attach The Z-Drive To The Sampler; Attach The Probe To The Sampler; Install Additional Channels - Hach QuikChem 2 Serie Manual Del Usaurio

Attach the Z-drive to the sampler

Refer to the instructions that come with the sampler.

Attach the probe to the sampler

When the probe is installed, make sure that the probe is flush with the hole in the guide plate. Refer
to Figure 2.
Note: Always move the sliders with the wheel on the sampler to prevent damage to the tubing.
Figure 2 Probe installation
1 Probe guide plate (single probe
installation)
2 Probe guide plate (dual probe
installation)
3 Slider wheel

Install additional channels

If additional channels were ordered, attach the channels that are shipped separately. Use the
documentation that is shipped with the channels.
8 English
4 Probe slider
5 Probe
6 Tie wrap
7 Slider knobs