Electrical Requirements - Airwell MFH Manual Del Usuario

OPERATING METHODS
USAGE NOTICE

Electrical Requirements

Electrical Shock Hazard
■ Plug into a grounded 3-prong outlet.
■ Do not remove ground prong.
■ Failure to follow these instructions can result in
■ Power supply must be suitable for the rated voltage and have a special circuit for AC, and diameter of the power cord
should be large enough.
■ A time-delay fuse or time-delay circuit breaker is recommended.
■
■ The wiring operation must be performed by the professional personnel by following national regulations. There must
circuit. Do not connect earth wire to water pipe or gas pipe. When the air conditioner is not used, please pull out the
power plug or cut off power supply.
Names and Functions Remote Controller
7 6 5 4
5 OPERATING METHODS
WARNING
■ Do not use an extension cord.
■ Do not use an adapter.
8
9
4 3 2 1
OPERATING METHODS
Control panel and the function
1.ON/ OFF OPERATION BUTTON
This button turns the air conditioner ON and OFF.
2.SLEEP
Press this button to turn the SLEEP mode ON or OFF.
3.FAN SPEED SELECTOR BUTTON
Low speed. Medium speed. High speed.
Hold down this button for at least 3 seconds to activate ION function (Optional)
4.TEMPERATURE SETTING BUTTONS
- ( cooler ) Press this button to decrease the set temperature.
+ ( warmer ) Press this button to increase the set temperature.
5.MODE SELECTOR BUTTON
Press this button to modify the air conditioner mode.
Cooling: The air conditioner makes the room cooler.
Dehumidification ( dry ):The air conditioner reduces the humidity in the room.
Fan :The air conditioner circulate the air.
Auto(Optional):
When this setting is selected, the air conditioner calculates the
difference between the thermostat setting and the room temperature
and automatically switches to the " cool" , "dry" or " heat" mode.
6.TIMER BUTTON
1) Press the TIMER button to select the desired timer.
2) Press the + or - button until the desired value is displayed.
3). Press the TIMER OFF button to activate the timer.
Displayed when the " timer on " is set and activated
Displayed when the " timer off " is set and activated
7.SWING BUTTON
Press SWING button to activate the supply aire flap to auto swing, if you push this button again, the flap stops
immediately.
8.LED DISPLAY: Set temperature or show room temperature(Dry/Fan mode)
9.POWER MANAGEMENT INDICATION
Indicate that the air conditioner is in thermostat off status.
Auto fan speed
OPERATING METHODS 6