User Notices - Airwell MFH Manual Del Usuario

TROUBLESHOOTING
If a malfunction occurs, please check the following before maintenance:
Troubles Possible Causes
The power supply is not connected well.
The power plug is not inserted tightly.
The air conditioner does not start.
Power plug or socket is malfunctioning.
The fuse is broken.
Is TIMER ON in operation?
1. The room temp. is lower than the set
Although it was set to COOL
temp.
mode, there is no cool wind.
2. The evaporator has frosted over.
Although it was set to DRY
1. The evaporator is frosted over.
mode, there is no cool wind.
Full water protection
The LED displays "P1"
11 TROUBLESHOOTING
Solutions
1. Insert the power plug tightly.
2. Have an electrician replace the power
plug or socket.
3. Have an electrician replace the fuse.
Cancel the "SET TIMER" operation or to
wait until auto running.
1. This is a normal phenomenon.
2. Unit is running in defrosting mode, it
will resume running in original mode
after defrosting.
1. Unit is running in defrosting mode, it
will resume running in original mode
after defrosting.
1. Drain out water through drainage
hose.
2. If the malfunction persists, please call
the maintenance man.

USER NOTICES

• Do not install the unit in a sealed place, and keep well ventilated, to avoid malfunctions.
Location
• Do not install the unit where it will be exposed to direct sunlight, in order to avoid loss
• Do not install the unit in a damp place, which may cause electrical leakage.
• Please do not install the unit in the following places:
Wrong places Please pay attention the following people:
1) Young children, medically compromised people.
2)
3) People who are very tired, drunk or who have taken sleep medication.
• Do not step on or put anything on the top of the unit; it will slow and a malfunction may
occur.
• Do not expose the body to a cold wind for a long time; this can cause health problems.
• The unit should be placed about 1 m or more away from a TV, or it will be affected by
its electromagnetic radiation.
• The air inlet/outlet must not be obstructed, for this will cause a malfunction.
• Do not insert your hands or a stick into the air inlet or outlet. Pay more attention
especially to young children, otherwise an accident may occur.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service
• The appliance must be positioned so that the plug is accessible.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they are under supervision or instruction concerning the use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
GPC09AE-K3NNA7A can be connected only to a supply with system impedance of no
more than 0.328 ohms. If case necessary, please consult your electricity supply authority
for system impedance information.
USER NOTICE 12