Foot Control; Installation - NSK VarioSurg 3 Manual De Operación

4-2 Foot Control

(c) Program Selection Button
(b) Coolant Flow Level
Selection Button
(a) Ultrasonic ON-OFF Button
To activate Tip Piezo vibration depress this control.
(b) Coolant Flow Level Selection Button
The Coolant Flow can be selected from 5 levels. Each time the button is depressed the flow will increase by 1
level. If the button is depressed when the Flow is in the level 5 it returns to level 1. (Level 0 cannot be selected
for the Coolant Flow.)
(c) Program Selection Button
A specific Program Number can be selected.
Each time the button is depressed the Program Number increases by one. When the button is held down for
approximately 1 second the program returns to the previous number.
(d) Burst Output Mode Selection Button
Burst Output Mode setting can be selected.
5

Installation

5-1 Connection of the LED handpiece & cord
1) Position the Handpiece Cord so that the
aligned with the mark on the Control Unit. Firmly push the Cord
Coupling into the Handpiece Cord Socket until it clicks.
2) Confirm that the Cord Coupling is properly locked in position by
pulling it gently.
To disconnect the Coupling pull back the Lock Joint then pull back
further to disconnect the cord.
mark is facing up and is
8
Foot Control Cord Plug
(d) Burst Output Mode
Selection Button
(a) Ultrasonic ON-OFF button
Mark
Lock Joint
Fig. 1