Britax ROUNDABOUT Guia Del Usuario página 11

BRITAX Child Safety, Inc.
Lap-Shoulder Belt Installation
1. Remove the tether from
the pouch and place it
up and over the child
seat back.
2. Adjust this child seat to
position 1 or 2 and place
forward-facing on the
vehicle seat (see page 25).
Ensure that no more than
3 in. (7.6 cm) of the base
hangs over the edge of the
vehicle seat.
IMPORTANT: Your child
seat may not perform as
intended if the base of the
child seat is not flat on the
vehicle seat.
3. Loosen the harness.
a. Lift harness adjuster
lever and pull both
harness straps
forward.
b. Remove the infant
positioning pillow
and unbuckle the
harness.
4. Pull the seat cover
forward to access the
forward-facing belt path.
5. Open the green lock-off
closest to where the vehicle
belt will be buckled.
a. Open the locking tab.
b. Open the clamp.
6. Route the vehicle belt
through the forward-facing
belt slots, ensuring the
vehicle belt is not twisted,
then buckle.
7. Push down into the rear
of the child seating area
with moderate force while
removing all slack from
the bottom (lap) part of the
vehicle belt and close the
lock-off.
IMPORTANT: Both the
vehicle lap and shoulder
belts must be routed
through the lock-off.
16
3"
Locking
5a
Tab
5b
Clamp
8. Push down into the middle
of the child seating area
with moderate force while
pulling the top (shoulder)
part of the belt between
the belt slots to remove
any remaining slack
through the lock-off.
9. Attach the tether to a
designated anchor (see
vehicle owner's manual)
and remove all slack
(see pages 28). Store the
excess webbing in the
elastic strap.
10. Replace the seat cover.
Forward-Facing Installation with Lap-Shoulder Belt
9 Check that all connections are secure and straps are not
twisted.
9 Check that no more than 3 in. (7.6 cm) of the base hangs
over the edge of the vehicle seat.
9 Check that the child seat cannot be moved front to back
or side to side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 Check that any excess tether webbing is contained within
your vehicle and secured in the elastic strap.
ROUNDABOUT User Guide
17