Britax ROUNDABOUT Guia Del Usuario página 9

BRITAX Child Safety, Inc.
Lap Belt Installation
1. Loosen the harness.
a. Lift harness adjuster
lever and pull both
harness straps
forward.
b. Remove the infant
positioning pillow and
unbuckle the harness.
2. Recline the unoccupied
child seat to position 3
and place rear-facing on
the vehicle seat (see page
25). Ensure that no more
than 3 in. (7.6 cm) of the
base hangs over the edge
of the vehicle seat.
3. Pull the seat cover
forward to access the
rear-facing belt path.
4. Route the vehicle belt
through the rear-facing
belt slots, ensuring the
vehicle belt is not twisted
and buckle the seat belt.
NOTE: The buckle should
be in the inner slot and
lying away from the belt
path.
IMPORTANT: Do not
use lock-offs for lap belt
installations.
5. Push down on the middle
of the child seat while
pulling the vehicle belt to
remove all slack.
NOTE: Ensure that the
vehicle belt is locked as
directed by your vehicle
owner's manual.
12
6. Replace the seat cover.
Rear-Facing Installation with Lap Belt
3"
9 Check that all connections are secure and straps are not
twisted.
9 Check that no more than 3 in. (7.6 cm) of the base hangs
over the edge of the vehicle seat.
9 Check that the child seat cannot be moved front to back
or side to side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 Check that the back angle of the child seat is 30° – 45°
from vertical (not to exceed 45°) when the car is parked
on a level surface. See "Seat Positions" on page 25.
ROUNDABOUT User Guide
13