Basic Operation; Image Projection; Basic Procedure - Sim2 Multimedia Mico 50 Manual De Uso E Instalación

MiCO 50
3.

Basic Operation

image Projection

Basic Procedure

Connect the required external equipment to the projector
before operating the following procedures.
•
The language preset at the factory is
info
If you want to change the on-screen display
to another language, reset the language
according to the procedure on page 18.
1 Plug the power cord into the wall outlet. Press
the power switch to turn on the projector.
2 Press 0 on the remote control or
keypad of the projector.
•
The power indicator illuminates blue, and the projector
enters power on mode.
•
The power indicator illuminates,
note
indicating the status of the LED.
Red: The power is ready.
Blue: The image is displayed
•
Press 0 on the remote control to turn on the
"Source" selection menu when in normal
operation.
3 Press the source button on the projector to select
the inPUT mode.
KEY 1 Selects the source Composite.
KEY 2 Selects the source S-Video.
KEY 3 Selects the source Component.
KEY 4 Selects the source Graphics RGB.
KEY 5 Selects the source HDMI 1.
KEY 6 Selects the source HDMI 2.
KEY 7 Selects the source SCART
•
When a signal is not received,
note
"NO SIGNAL" will be displayed.
•
Set SCART enabled before
selecting the SCART input.
4 Press on the remote control or
Power
English.
on the
Keys 1-7
selects the sources
directly.
1 Composite
2 s-ViDEO
3 COMPOnEnT
4 gRAPhiCs RgB
5 hDMi 1
6 hDMi 2
7 sCART
on the projector to turn off the projector.
17
p, q, t, u buttons
Remote control sensor
MEnU
Blue lED
Red lED
MENU ESC SOURCE
Power button
LIGHT
EsC button
p, q, t, u
buttons
MEnU +/- button
ZOOM
F1
F2
FOCUS
source button
MENU ESC SOURCE
source
EsC