Troubleshooting - Sim2 Multimedia Mico 50 Manual De Uso E Instalación

MiCO 50

Troubleshooting

Problem
Projector does not start
No picture
faded
blurred
Noise
green on COMPONENT
dark / bright and whitish
too bright and whitish
Check
Projector power cord is not plugged into the wall outlet.
Projector power switch does not turn on.
Remote control batteries have run out.
The selected input mode is wrong.
Cables may be incorrectly connected to the rear panel of the projector.
Power to the external connected device is off.
The video signal format of the video equipment is not set correctly.
Picture adjustments are incorrectly set.
Adjust the focus
The projection distance exceeds the focus range.
(Component/VGA input only)
Perform "Frequency" adjustments also in component.
Perform "Phase" adjustments also in component.
Change the input signal type of the video equipment.
Picture adjustments are incorrectly set.
Picture adjustments are incorrectly set.
31