Step 4 - Turning On Your Monitor; Channel Selection - Angelcare AC401-A Manual Del Usuario

STEP 4 - TURNING ON YOUR MONITOR

1

CHANNEL SELECTION

1
3
14
2
When Parent Unit is turned ON
and Nursery Unit is OFF:
• No channel icon will
appear and Nusery Unit
icon will blink.
• Parent Unit will start
beeping after 1 minute.
5 seconds after beeping,
unit will shut itself OFF.
1) Press the Parent Unit ON/OFF button
for 2 seconds.
2) Slide ON the Nursery Unit Power
ON/OFF button.
NOTE:
The screen of the Parent Unit will show the
channel of transmission (C1 to C8) and after
5 seconds the room temperature and
function icons.
The connecting process should be done
within 30 seconds. If longer, the operation
will be ignored and you will have to start over.
If there is a lost connection
between the 2 units
(refer to troubleshooting):
• The Out-of-Range icon will
blink on the screen and the
Parent Unit will beep.
TO SELECT THE CHANNEL:
1) Press and hold the SELECT button
to enter channel mode.
2) Pressing either the UP or DOWN arrow
will change the channel your monitor
transmits on (C1 to C8).
3) Press the SELECT button again to
confirm your channel selection.
NOTE :
If the transmission is not clear, or if you hear
interferrence sounds, you should change
the channel.
2