Novoferm NovoSpeed Alu S Manual De Instalación página 9

4.5
GB
Installation of the complete top roller
1.
X
1.
X
• Assemble the complete top roller with the door panels, i.e. :
- bearing block, pulley and drive with torque support on the driving side
- bearing block and pulley at on the other side.
• Lift the entire package using a forklift truck and place the package with the block
bearings on the appropriate attachment points of the consoles (X).
• Tighten the mounting bolts of the bearing blocks and the drive, finger-tight.
• Align the shaft so it is parallel with the consoles.
• Maintain a distance of 10 - 30 mm between the wall and the roller.
• After a final check tighten all mounting bolts and secure the torque support to
the guide rail in the appropriate bore holes (1).
14
4.6
Tighten and secure
the free end manually!
X
Clamping washer
X
Attaching the tension belts
M8 hex screws
(2X)
Aluminium pulley
Flush-mounted M8
screws (2X)
Wrap the tension belt
1.5 - 2 times around it
Reverse plate
Clamping washer
Plastic guide rail
Belt holder with
plastic guide rail
GB
15