GE JGP18 Guía De Uso, Cuidado E Instalación página 30

PROBLEM
BURNERS DO
NOT LIGHT
BURNERS HAVE
YELLOW OR
YELLOW-TIPPED
FLAMES
FLAME IS UNEVEN
FLAME LIFTS OFF
THE PORTS
BURNER FLAMES VERY
LARGE OR YELLOW
BURNER CONTROL
KNOB WILL NOT TURN
FAN DOES
NOT WORK
If you need more help...call toll free:
®
GE Answer Center
800.626.2000
consumer information service
30
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
• Make sure electrical plug is plugged into a live power outlet.
• Check for a blown circuit fuse or a tripped main circuit breaker.
• Check to be sure igniter is clicking. If igniter doesn't click, turn control knob
off and clean igniter.
• Check to be sure appliance regulator is set for correct fuel.
• Check to be sure inlet pressure is adequate.
• Burner parts not replaced correctly.
• Check to be sure burner ports or igniter ports are not clogged.
(A) Yellow flames — (B) Yellow tips on outer
Call for service
• If burner flame looks like (A), call for service. Normal burner flames
should look like (B) or (C), depending on the type of gas.
NOTE: The grill burner will show orange flames from grease drippings.
• Burner ports may be clogged.
• Flame setting may need to be adjusted.
• Shutter on the mixer tube needs to be closed until the flame settles on the burner
ports. See Minor Adjustments You Can Make section in this guide.
• If cooktop is connected to LP gas, check all steps in
the Installation Instructions.
• When the knob is at the OFF position, it must be pushed in before it can be
turned, and it can only be turned in a counterclockwise direction. When the
knob is at any other position, it can be turned in either direction without being
pushed in.
• Fan control knob must be turned in clockwise direction to turn fan on.
(C) Soft blue flames —
cones — Normal for
LP gas
Normal for
natural gas