Accessing The Control Unit Settings; Loading The Default Parameters - V2 ALFARISS Manual De Instrucciones

6 - ACCESSING THE CONTROL
UNIT SETTINGS
1. Press and hold the OK key until the display shows the menu
desired
2. Release the OK key: the display will show the first item in the
sub-menu
-PrG
Programming the control unit (Chapter 11)
-Cnt
Cycle counter (Chapter 10)
-SEt
Installation menu (Chapter 8)
-dEF
Loading the default parameters (Chapter 7)
WARNING: in case no operation is carried out for
more than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.
7 - LOADING THE DEFAULT
PARAMETERS (
If necessary, it is possible to restore all parameters to their
standard or default values (see the final summary table).
PLEASE NOTE: This procedure results in the loss of all
customised parameters.
1. Press and hold the OK key until the display shows
2. Release the OK key: the display shows
OK key if it is desired to exit this menu)
3. Press the i key: the display shows
4. Press the OK key: the display shows
5. Press the i key: the display shows
6. Press the OK key: all parameters are overwritten with their
default values (see Chapter 11), the control units exits
programming mode and the display shows the control panel.
39
dEF )
-dEF
ESC
(only press the
dEF
no
Si