Accessing The Control Unit Settings; Quick Configuration - V2 ALFARISS Manual Del Usuario

• Times being more than 10 minutes will be viewed as follows:
each time you press key, current time value increases of half a
minute; vice versa, each time you press the i key, current time
value decreases of half a minute.
By holding down the key, you can quickly increase the time
value, up to reach the max. value allowed for this item. Vice
versa, by holding down the i key, you can quickly decrease
the time value down to reach
In some circumstances, setting the value to 0 means that the
relevant function is disabled, in this case, 'no' will appear instead
0.0
of ".
By pressing on OK you will confirm the displayed value and
you will return to the configuration menu.
Value menu setup
Value menus are similar to time menus; however, the setup value
can be any number.
or i keys, the value will increase or
By holding down
decrease slowly.
By pressing on OK you will confirm the displayed value and
you will return to the configuration menu.
0.0
".
6 - ACCESSING THE CONTROL
UNIT SETTINGS
1. Press and hold the OK key until the display shows the menu
desired
2. Release the OK key: the display will show the first item in the
sub-menu
-PrG
Programming the control unit (full menu)
-Cnt
Cycle counter
-SEt
Self-learning of the limit switch position
-dEF
Loading the default parameters
WARNING: in case no operation is carried out for
more than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.

7 - QUICK CONFIGURATION

This paragraph concerns a quick procedure to set the control
unit and set it at work immediately.
We recommend following these instructions, in order to
check quickly the correct operation of control unit, motor
and accessories, and then changing the configuration in
case of any non-satisfactory parameter.
1. Call up the default configuration: see paragraph "LOADING
OF DEFAULT PARAMETERS"
2. Set items dir, StoP, Fot1, Fot2, CoS1, CoS2 based on the
gate
direction and the installed security devices.
Please refer to the paragraph "CONTROL UNIT
CONFIGURATION" for the item position inside the menu, as
well as for the available options for each item.
3. Start the self-learning cycle: see the section on SELF-LEARNING
OF THE LIMIT SWITCH POSITION
49