Tabla de contenido
Publicidad
PELTOR ALERT – ACTIVE-VOLUME
HEARING PROTECTOR RADIO
The Peltor ALERT active-volume hearing protector radio,
M2RX7*, provides comfortable, effective protection from
harmful noise. At the same time, it provides added safety
because its active volume function attenuates loud noises
while amplifying weak ones. And the AM/FM stereo radio
receiver provides extra working pleasure. The Peltor ALERT
is ideal for professionals and private individuals alike – per-
fect for mowing the lawn or practicing on the target range.
For complete two-way communication, the Peltor ALERT
also comes in a headset model.
Read these instructions carefully to ensure the best pos-
sible benefit from your Peltor ALERT.
(A) WHAT IS WHAT?
1. Extra broad headband (M2RX7A) with soft padding
for ideal comfort throughout the working day.
Specially designed helmet attachments (M2RX7P3E)
with slots for attaching a visor and rain shield.
2. Individually sprung headband wires of stainless steel
provide an even distribution of pressure around the
ears. Maintains its resilience better than regular plastic
headbands through a wide range of temperatures.
3. Low, two-point fasteners and easy height adjustment
with no protruding parts.
4. Soft, wide foam/fluid-filled ear cushions with built-in
pressure-relief canals for low pressure, effective sealing
and individual comfort.
5. Short, flexible antenna for stereo reception, with a low
attachment point and high receptivity.
6. Audio input allows you to listen to a communication
radio. Note: See the maximum permitted audio sig-
nal.
7. Battery cover for easy battery replacement. The Pel-
tor ALERT can operate for 90 hours in the mode that
consumes the most power.
8. Microphones for active volume capture and amplify
weak sounds up to the specified maximum level.
9. On/off and volume controls.
10. FM/AM switch (frequency range FM 88–108 MHz, AM
540–1700 kHz).
11. Channel search control. Switches automatically from
stereo to mono for the best reception in the event of a
weak signal.
12. Active volume controls. On/Off and volume.
13. Speech microphone (on some models only) allows
two-way communication by a com radio etc.
14. Connector cord (only on models with speech mike)
for connecting a com radio etc using the Peltor adapter
system.
INSTRUCTIONS FOR USE
Unscrew and open the battery cover. Insert the two enclosed
1.5-volt AA batteries. Make sure that the + and – poles are
in the correct position.
2
RADIO FUNCTION
On/Off, volume and channel settings. You switch the radio
on and off and adjust the volume by turning the volume
knob (9). Use the channel selector knob (11) to select
a channel.
AM/FM
To switch between AM and FM reception, use the switch
on the front of the right shell (10).
AMBIENT SOUNDS
To switch the ambient sound amplification on and off and
adjust its volume, turn the volume control knob (12).
B) ASSEMBLY/CONFIGURATION
Unscrew and open the battery cover. Insert the two enclosed
1.5-volt batteries. Make sure that the + and – poles of the
battery are in the correct position (see the figure in the
cover). Operating time approx. 100 h. You can also use
rechargeable batteries.
Headband:
(B:1) Slide out the cups. Place them over your ears so that
the ear cushions fit snugly.
(B:2) Adjust the height of the cups to a snug, comfortable
fit by pulling the cup up or down while pressing the
headband down.
(B:3) The headband should lie across the top of the
head.
Helmet attachment:
Snap the helmet attachment into the slot on the helmet
(see fig. B:4). When in use, you must press the headband
wires inwards until you hear a click on both sides, from
ventilation to working mode. Ensure that the cup and the
headband wires in working mode do not press on the edge
of the helmet so that noise leakage can occur.
Note: The ear cups can be set in three positions: Work-
ing position (B:5), ventilation position (B:6) and parked
position (B:7).
Important! For the best protection, brush aside hair around
the ears so the ear cushions fit snugly against the head.
Spectacle frames should be as thin as possible and fit
close to the head.
IMPORTANT USER INFORMATION
• The hearing protector radio must be put on, adjusted,
cleaned and maintained in accordance with the instruc-
tions in this manual.
• Wear the hearing protector radio 100% of the time you
spend in noisy environments for full protection.
Publicidad
Tabla de contenido
