Assembly Steps - Tunturi Cardio Fit Bike B30 Manual Del Usuario

CAUTION
• Place the equipment on a firm, level
surface.
• Place the equipment on a protective
base to prevent damage to the floor
surface.
• Allow at least 100 cm of clearance
around the equipment.
Refer to the illustrations for the correct
assembly of the equipment.

ASSEMBLY STEPS

Assembly step 1
• Fit front stabilizer by using the shown
hardware.
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
User Manual • Cardio Fit Bike B30
Assembly step 2
• Connect the wires from upright tube
and main frame and hook up the
tension cable as shown in pictures
below (set tension knob to max. level
to ease the cable connection) before
sliding the upright tube in position.
• Use the enclosed Allen key to tighten
the fastening screws, turning them
clockwise.
•
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Step 1
Step 2
Step 3
GB
5